New version of the GoPro BL Gimbal with landing gear Front view GoPro 1/2 FOV Work in progress….
READ MORE »Brushless gimbal mechanics
My approach to brushless gimbal mechanics, all made in aluminum grade 7075 and carbon fiber, it a early design I will made the first prototype and some changes in the camera fixation when dealers start selling the controllers and motors. I’m going to use 2 Turnigy SK 750kv motors in this prototype, that I rewind [...]
READ MORE »400 FPV
Prototype of the FPV400 for 8″ props Size difference, on the left my QAV RE version with 550mm of the left the little 400mm Work in progress . . .
READ MORE »FPV QAV RE with Sony AS-10
The new version, now with machined 7075 aluminum arms and a 5 th rubber dumper, for remove some flexibility that occur on the upper plates when using large batteries. This frame was made for the new Sony AS-10/15 camera, it as slide rail for more freedom in adjusting the CG of the frame, now is [...]
READ MORE »Fat Shark RCV922 with dual receiver 2.4ghz and 5.8ghz
This modification will allow to receive in 2.4ghz or 5.8ghz just with a switch also the video in is working in bout both frequency’s. The receiver was bought on eaby and was very cheap, after dissembling it I had a very nice surprise it uses a RC5808 that is a very good 5.8 receiver and [...]
READ MORE »GoPro with lens filter
Very easy modification to enhance the GoPro optics, the adapter is a 25mm to 37mm step up adapter was bought on ebay and it cost about $5 USD, the filters can be bought on ebay too a ND (neutral density) filter cost about $5 USD. The best ting is to bought a ND4 for low [...]
READ MORE »RCG OKTO PRO v2
This is the new version of our octocopter for heavy duty work. The main spec are: – Carbon tube 3K Ø25mm – Upper center plate in carbon fiber 3K 2mm – Lower center plate in carbon fiber 3K 2.5mm – Arms and motors holder in Acetal Derlin – 4 units for removing the low frequency [...]
READ MORE »New version of RCG Gimbal 135mm & 160mm
The new version of my original RCG135mm, now with more space, lighter and more robust than the first version, current weight is 475 grams ready to work. RCG135mm specs: -Roll axes 60 degrees total movement, 30 degrees for each side with 3 turns potentiometer – Tilt axes 180 degree total movement with external potentiometer – [...]
READ MORE »FPV Quad inspired by the QAV500
On the web exist several designs that share the same concept dirty / clean part, I think that the original and the first to be build was the QAV500 from getfpv.com. In OpenPilot forum, I found similar open source designs, some projects have very good ideas that I implemented in my project. My version is [...]
READ MORE »